GE GSF25XGWBB Owner's Manual And Installation Instructions page 27

CONNECTING THE REFRIGERATOR
1
TO THE HOUSE WATER LINE
(icemaker and dispenser models)
A cold water supply is required for automatic
icemaker and dispenser operation. If there
is not a cold water supply, you will need to
provide one. See Installing the Water Line
section.
NOTES:
• Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
• If your refrigerator does not have a water
filter, we recommend installing one if your
water supply has sand or particles that could
clog the screen of the refrigerator's water
valve. Install it in the water line near the
refrigerator. If using GE SmartConnect
Refrigerator Tubing Kit, you will need an
additional tube (WX08X10002) to connect
the filter. Do not cut plastic tube to install
filter.
If you are using copper tubing, place a
A
compression nut and ferrule (sleeve) onto
the end of the tubing coming from the house
cold water supply.
If you are using the GE SmartConnect
tubing, the nuts are already assembled to
the tubing.
If you are using copper tubing, insert
B
the end of the tubing into the refrigerator
connection, at the back of the refrigerator,
as far as possible. While holding the tubing,
tighten the fitting.
If you are using GE SmartConnect
insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression
nut until it is hand tight. Then tighten one
additional turn with a wrench. Overtightening
may cause leaks.
Installation Instructions
™
™
tubing,
™
27
C Fasten the tubing into the clamp provided to
hold it in position. You may need to pry open
the clamp.
Tubing Clamp
1/4"
Compression Nut
Ferrule
(sleeve)
Refrigerator
SmartConnect
Connection
TURN ON THE WATER SUPPLY
2
Turn the water on at the shutoff valve
(house water supply) and check for any leaks.
PLUG IN THE REFRIGERATOR
3
Before plugging in the refrigerator, make sure
the icemaker power switch is set to the O (off)
position.
See the grounding information attached to
the power cord.
1/4" Tubing
™ Tubing