Correcting Volume Differences During Playback; Enabling Lipsync Adjustment - Yamaha AVENTAGE RX-A680 Owner's Manual

n
Setting Compressed Music Enhancer
Enables/disables Compressed Music Enhancer.
Option menu
"DSP/Surround" > "Enhancer"
Settings
Off Disables Compressed Music Enhancer.
On Enables Compressed Music Enhancer.
NOTE
▪ This setting is applied separately to each input source.
▪ You can also use ENHANCER on the remote control to enable/disable Compressed Music Enhancer.
▪ For details on Compressed Music Enhancer, see the following:
– "Playing back digitally compressed formats with enriched sound (Compressed Music Enhancer)" (p.44)

Correcting volume differences during playback

n
Correcting volume differences between input sources
Corrects volume differences between input sources. If you are bothered by volume
differences when switching between input sources, use this function to correct it.
Option menu
"Volume Trim" > "Input Trim"
Setting range
-6.0 dB to +6.0 dB (0.5 dB increments)
NOTE
This setting is applied separately to each input source.
n
Adjusting the subwoofer volume
Fine-adjusts the subwoofer volume.
Option menu
"Volume Trim" > "Subwoofer Trim"
Setting range
-6.0 dB to +6.0 dB (0.5 dB increments)
n
Correcting volume difference between Zone A and
Zone B
If you are bothered by volume difference between Zone A/B, adjust the volume for
Zone B.
Option menu
"Volume Trim" > "ZoneB Trim"
Setting range
-10.0 dB to +10.0 dB (0.5 dB increments)
NOTE
This setting is not effective when "ZoneB Volume" in the "Setup" menu is set to "Async.". For details, see the
following:
▪ "Adjusting the volume for Zone B in conjunction with the volume for Zone A" (p.106)

Enabling Lipsync adjustment

Enables/disables the adjustment configured in "Lipsync" in the "Setup" menu.
NOTE
For details on "Lipsync" in the "Setup" menu, see the following:
▪ "Setting the adjustment method of the Lipsync function" (p.103)
Option menu
"Lipsync"
Settings
Off Disables the "Lipsync" adjustment.
On Enables the "Lipsync" adjustment.
NOTE
This setting is applied separately to each input source.
83
En