Component Service Information - Hoshizaki SRC-14H Service Manual

B. Component Service Information
• When replacing a component listed below, see the notes to help ensure proper
operation.
• When replacing evaporator assembly and water circuit components, make sure
there are no water leaks after the repair is complete.
• Seal bolts must be replaced once removed because seal material is one-time use
only. If new seal bolts do not have preapplied threadlocker, apply Loctite 243 or
equivalent threadlocker to seal bolt threads. Tighten to the torque values listed
below.
Torque for F-1001 and Smaller: 11.1 ft-lb/15 N·m
Torque for F-1500 and Larger: 25.8 ft-lb/35 N·m Tighten 2 times. Allow at least
5 sec. in between each tightening.
Component
Compressor • Install a new drier, start capacitor, and start relay.
Upper and • Inspect the upper bearing for wear. See "IV.B.1. Upper Bearing Wear Check." Replace if
Lower Bearings necessary.
• When replacing the upper bearing it is advised to also change the lower bearing at the
same time.
Evaporator • Install a new drier.
• Inspect the mechanical seal and O-ring prior to installing the new evaporator. If worn,
cracked, or scratched, the mechanical seal should also be replaced.
Gear Motor • Install a new gear motor capacitor.
NOTICE
Notes
46