KitchenAid KDRS463VBU Installation Instructions Manual page 16

2. Attach the supplied water filter mounting ring and screw at
the recommended location.
3. Attach filter to the mounting ring.
Mounting ring and screw
1½" (3.8 cm) clearance
Connect to Home Water Supply
1. Make connection to the cold water supply line.
A leak-tight connection to the
■
approved water supply line must be provided.
Check local codes for type of connection required.
■
Flexible codes-approved water supply line must be
■
cut with a tubing cutter so the ends are concentric
and without burrs.
NOTE: It is recommended that the cold water line be soft water.
Connect to Water Filter Inlet (yellow)
NOTE: Use the quick-connect stem and/or elbow adapter
fittings in the combination needed for your installation
configuration.
1. Attach the supplied
3 / " to
8
quick-connect adapter fitting to the yellow water filter inlet
connection by pushing the quick-connect fitting past the
O-ring until you hit the backstop.
A
A. Quick-connect elbow adapter fitting
B. Quick-connect stem adapter fitting
2. Connect the flexible codes-approved water supply line
(not provided) from the home cold water supply pipe to the
quick-connect adapter fitting you just installed on the filter
inlet (yellow) side of the water filter.
3. Pull tube to ensure it is secured.
A. / " water supply tubing
1
4
B. O-ring
C. Backstop
16
/ " flexible codes-
1
4
1 / " stem or 3 / " to 1 / " elbow
4 8 4
B
If you need to release tubing:
Push in collet to release tubing. With collet held in, pull tubing
straight out.
A
Connect to Water Filter Outlet (blue)
1. Attach the supplied / " to
3
8
quick-connect adapter fitting to the blue water filter outlet
connection by pushing the quick-connect fitting past the
O-ring until you hit the backstop.
2. Connect another piece of flexible codes-approved water
supply line to the quick-connect adapter fitting you just
installed on the filter outlet (blue) side of the water filter.
3. Pull tube to ensure it is secured.
Sink
Water
supply
connection
Water supply tubing
to cold water supply
Shutoff
valve
4. Route flexible codes-approved water supply line through
under-sink cabinet and oven cabinet cutout.
5. Connect the flexible codes-approved water supply line to the
range copper tubing, using a
B
C
A
A. To home water supply
B. Rear of cabinet cutout
C. Flexible codes-approved water supply line from home
water supply
D. / " to / " water supply union (supplied in water filter kit)
1 1
4 4
E. Oven copper tubing
F. Range front
A. Collet
/ " stem or / " to / " elbow
1 3 1
4 8 4
Water supply tubing to range
Yellow
WATER
IN
Filter
/ " to / " water supply union.
1 1
4 4
D
E
Blue
WATER
OUT
F