Whirlpool WETLV27FW Installation Instructions Manual page 20

5.
Move washer/dryer to nal location
Outer Access Panel
(27" model shown)
If you are working in a closet or recessed area: move the
washer/dryer into its nal location and remove cardboard
from under washer/dryer. Remove the outer access panel
by removing 2 (24" models) or 3 (27" models) Phillips-head
screws and one bumper (27" models only), located at the top
of the access panel. Remove inner access panel (27" models
only) by removing clip, cover, and 2 screws. Set panels,
screws, clip, inner access panel cover, and bumper aside.
Complete hookup of water hoses and vent. Replace access
panels upon completion of washer/dryer installation.
6.
Check for leaks
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
20
Inner Access Panel
(27" models only)
7.
Secure drain hose
Laundry Tub Standpipe
4.5"
4.5"
4.5"
4.5" 4.5" (114 mm)
(113 mm)
(114 mm)
(113 mm) (113 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with shipping strap removed earlier
(27" models) or plastic strap included in the parts package
(24" models).
It is the responsibility of the installer to install and secure the
drain hose into the provided plumbing/drain in a manner that
will avoid the drain hose coming out of or leaking from the
plumbing/drain.
Wall
4.5"
4.5"
4.5"
(114 mm) (113 mm) (113 mm)