Cust Om Er Responsibilit Y; Operator Presence; Tires; Blade Maintenance - Swisher ZT2760A Owner's Manual

Operator Presence System
Be sure the operator presence and interlock systems are working properly. If your mower does not function as
described, repair the problem immediately.
The engine should not start unless the parking brake is engaged and the PTO (Blade Engagement
– See OPERATION FEATURES section of this manual) switch is disengaged (pressed down).
When the engine is running, the operator should never leave the seat without first setting the parking
brake and shutting off the engine.
When the engine is running and the PTO switch is engaged, any attempt by the operator to leave
the seat without first disengaging the PTO switch, should shut off the engine.
When the engine is running and the control levers are rotated in, the operator should never attempt
to leave the seat without rotating the control levers out, shutting off the engine and engaging the
parking brake.
The PTO switch should never engage without the operator on the seat.

Tires

Maintain proper air pressure in all tires ( SEE SPECIFICATIONS section)
Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.
Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

Blade Maintenance

CAUTION
Stop engine and remove ignition key for safety. Disconnect spark plug wire. Wear heavy, thick gloves when
holding onto blade. Avoid the sharp edge of the blade.
For best results, mower blades must be kept sharp. Replace bent or damage blades.
Safely raise front of mower. SEE WARNING
Hold or block blade from turning.
Loosen blade nut and remove blade.
Replace blade, (SEE SPECIFICATIONS).
Battery
To clean battery and terminals
Remove terminal guard.
Disconnect the BLACK battery cable first, then the RED battery cable and remove the battery.
Rinse the battery with plain water and dry.
Clean terminals and battery cable ends with wire brush until shiny.
Coat terminals with grease or petroleum jelly
Reinstall battery
Reconnect the battery cables
CUSTOMER RESPONSIBILITIES
10
10
WARNING
When it is necessary to raise the mower for
any repair or service, use jackstands to
provide adequate support. DO NOT rely on
hydraulic or mechanical jacks
WARNING
The battery contains sulfuric acid and
electrolytes which are poisonous and
corrosive.