Drain; Flooring; Surrounding Temperature; Alcove Or Closet Installation - Samsung WF81FE Series User Manual

Hide thumbs Also See for WF81FE Series:

Table of Contents

Drain

Samsung recommends a standpipe height of 65 cm. The drain hose must be routed through the drain hose

clip to the standpipe. The standpipe must be large enough to accept the outside diameter of the drain hose.

The drain hose is attached at the factory.

For best performance, your washing machine must be installed on a solidly constructed floor. Wooden floors

may need to be reinforced to minimize vibrations and/or unbalanced loads. Carpeting and soft tile surfaces

are contributing factors to vibrations and the tendency for your washing machine to move slightly during

the spin cycle.

WARNING: Never install your washing machine on a platform or poorly supported structure.

Do not install your washing machine in areas where water may freeze, since your washing machine always

retains some water in the water valve, pump, and hose areas. Frozen water in the lines can cause damage to

the belts, the pump, and other components.

To operate safely and properly, your new washing machine requires the following minimum clearances:

Sides

Top

Rear *

Front

If both the washing machine and a dryer are installed together, the front of the alcove or closet must have

an unobstructed air opening of at least 500 mm. Your washing machine by itself does not require a specific

air opening.

F400E_WF60F4E-03251H-05_EN.indd 13

25 mm

50 mm

500 mm

English - 13

2015-07-23

6:10:31

Table of Contents