Alarm; Alarm On - NEC N3105 User Manual

Super fine
Select the single shoot mode ,complete shoot ,press option :
Save :save the photo;
Set wallpaper : to set the photo as the main wallpaper ;
Send MMS: send the photo as the MMS'content;
Select the continue burst mode ,when complete shoot ,press option :
Save :save the photo;
Save all :save all the photos ;
Auto view :to show the photos as slide ;
Select the movie mode, complete shoot ,press option :
Play :play the video ;
Save :save the video .
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.

12.2 Alarm

This cell phone is available with three alarms, which are all the same in function and use. They may be
set to on or off separately.
Under alarm function box, the working state for five alarm groups shall be displayed.
The alarm on or off is indicated by different icon: for instance, when alarm is on, the icon 'on' and the
set alarm time following characters will be shown; when alarm is off, the icon 'off' is shown while the set
alarm time will not.

12.2.1 Alarm on

Upon the selection of an alarm by user, press the key select to enter this alarm state box to check its setting
in details.
Refer to the figure shown above：the time setting for alarm1 is 00:00, whereby 00:00 indicates the alarm
time; and the period is set to only once, meaning the alarm is on.
Self node
Brightness
焦距
N3105 's usermanual
第 58 页