Using The Projector
Use the control buttons on the projector control pad and the remote control to make quick
adjustments to the controls listed in the following section.
E
N
G
L
I
S
Standby/On
button
H
Input button
Mute button
Reset button
Menu button
Control Buttons
Press a control button to display a menu, then use the arrow buttons to adjust the selected control.
The buttons on the projector control pad and on the remote control are explained below:
Standby/On Button
Press the STANDBY/ON button to begin the warm-up period. The power LED flashes
green during warm-up and lights a steady green when the projector is ready to use.
The projector cannot be restarted within 60 seconds after it is turned off because the
projector enters a cool-down mode. This is a safety feature.
Input Button (Video and RGB Buttons)
Use the INPUT button on the projector or the Video and RGB buttons on the remote
control to select the input source.
Press the INPUT button on the projector to cycle through the input sources: RGB 1, RGB
2, Video, or S-Video.
On the remote control:
8
ViewSonic PJ700
Projector control pad
STANDBY/ON
MUTE
RESET
Figure 6: Projector and Remote Controls
Press the RGB button to select a computer (RGB) as the input source.
-
Press the Video button to toggle between Video and S-Video.
-
Standby/On
LED indicators
Menu
Magnify
Remote control
Video
RGB
Menu select
Reset
Position
Volume
Freeze
Mute
Blank
Timer
Auto