Maintenance - Kidde 21029713 User Manual

Operating and Alarm Characteristics
Function LED Display
Error/ serv- Red LED flashes every
ice alarm 30 seconds
Error Red LED
constantly on
Normal Red LED flashes with
Test/Reset beeps.
function
Event Green LED
Memory flashes every
10 seconds
Tamper Red LED
Resist constantly on
End of Red LED flashes
Unit Life two times every
Indicator 30 seconds

7. Maintenance

NOTE: This unit is sealed. The cover is not removable.
Due to the loudness of the alarm, we suggest that you place your
fingers over the sounder opening while testing your alarm.
CAUTION: Continuous exposure to the high sound level of this
!
alarm over an extended period of time may cause hearing loss.
Testing
To test the CO alarm, press and release the Test/Reset button, you will
hear 4 quick beeps – followed by 5 seconds of silence – followed by 4
quick beeps. Notice the red Alarm LED flashes when the unit alarms. The
alarm will then return to monitoring for carbon monoxide.
Battery Replacement
WARNING: If at any time you test the alarm and it does not
!
perform as described, have it replaced immediately.
NOTE: This CO alarm is not battery operated. However, this alarm is
equipped with 2 AA batteries backup – the 2 AA batteries are to supply
short term back-up during a power outage.
If installed, slide the battery door in the direction of the arrows to
release it. Remove the batteries and replace with two of the following
approved replacement Alkaline batteries:
• Energizer E91
• Gold Peak 15A
Replace the battery door.
Alarm Sound Unit Status
One quick beep Unit is in error condition
every 30 seconds
Constant alarm Very low batteries or
unit malfunction
4 quick beeps, Normal operation when
5 seconds silence, Test/Reset button is
repeated once pressed
None 100ppm or more
CO previously
detected
Constant Tamper resist
alarm (after feature
2 minutes) activated
Two quick End of unit life
beeps every
30 seconds
• Duracell MN1500, MX1500
• Golden Power GLR6A
Recommendation
Replace batteries.
If "Err" continues, unit
has malfunctioned.
Replace immediately. Unit
will not respond CO
CO not detected. Alarm
for test purposes only
Push button to clear
and test unit.
Plug unit into AC outlet.
Disable feature if desired.
(See Section 2)
Replace unit immediately.
Unit will not
respond to CO.