Ricoh Aficio MP C2000 Operating Instructions Manual page 58

Appendix
Note
❒ When you load paper in Paper Tray 1, 2, or 3 (LCT) or on the optional Lower
Paper Trays, load it print side up.
❒ Load paper into the bypass tray with the print side up.
❒ When using the bypass tray, it is recommended to set the paper orientation to L.
❒ You must manually specify the size of custom size paper when loading it on
the bypass tray.
❒ When loading paper in Paper Tray 3 (LCT), make sure the top of the stack is
no higher than the limit mark. The number of sheets you can load depends on
3 the thickness and condition of the paper.
❒ If you want to change the size of paper that can be loaded in Paper Tray 3
(LCT), contact your service representative.
❒ If multiple-sheet jams occur, load the paper sheet by sheet.
❒ Do not use paper designed for inkjet printers, as these may stick to the fusing
unit and cause a misfeed.
❒ We recommend you load OHP transparencies, and adhesive label sheets one
at a time.
❒ When loading OHP transparencies, check the front and back of the sheets,
and place them correctly, or a misfeed might occur. Set the paper orientation
to L.
❒ When loading OHP transparencies, set [Special Paper] in Bypass Tray Paper to
[OHP].
❒ When using OHP transparencies, fan them for each use. If you store the sheets
in the tray, they may adhere and may cause feeding problems.
❒ When copying onto OHP transparencies, remove copied sheets one by one.
❒ When loading postcards, thick paper (106-253g/m
label sheets, make sure the top of the stack is no higher than the limit mark.
The number of sheets you can load depends on the thickness and condition
of the paper.
❒ To load thick paper (106-253g/m
Paper] to [Thick Paper 1], [Thick Paper 2], or [Thick Paper 3].
❒ To print onto adhesive label sheets, set Bypass Tray Paper [Special Paper] to
[Thick Paper].
❒ When copying onto letterhead paper, the paper placing orientation is differ-
ent depends on which function you are using. See "Orientation-Fixed Paper
or Two-Sided Paper", Troubleshooting.
❒ If you load paper of the same size in the same orientation in two or more
trays, the machine automatically shifts to the other tray - except the bypass
tray - when the first tray in use runs out of paper. This function is called "Auto
Tray Switching". (However, if one tray has recycled or special paper, the set-
tings of the other trays must be the same for Auto Tray Switching to work. )
This saves interrupting a copy run to replenish paper when making a large
number of copies. See "General Features", and "Tray Paper Settings", General
Settings Guide.
44
2
, 28.5-67lb.), or adhesive
2
, 28.5-67lb.), set Bypass Tray Paper [Special