ViewSonic V1250 User Manual page 39

Microsoft windows xp convertible tablet pc edition

Hide thumbs Also See for V1250:

Table of Contents

Locate the memory expansion slot cover on the back of the Tablet PC shown

below. Remove the screw. Lift the memory door off the system.

Attention: Notice the notch on the extracted module. The notch's

off-center placement allows the module to fit into the socket only

in one orientation. The replacement module will be similarly

notched to help you place it properly into its slot.

To install the new module, place it into the memory socket. The

module will only fit in one orientation. Insert the module at an

angle of approximately 30 degrees into the empty memory socket.

Then press it firmly so that the contact edge is driven fully into the

receiving socket.

Pivot the module until the latches on both sides of the socket snap

into place. (You will feel it solidly click into place.)

Replace the Memory Slot Cover and the Screw. You have now

completed the memory upgrade.

ViewSonic Tablet PC V1250

Table of Contents