Vent System Preparation - Superior Fireplaces DRT2033TMN Installation And Operation Instractions

Innovative Hearth Products
DRT2000 and DRC2000 Direct-Vent Fireplaces

VENT SYSTEM PREPARATION

Select a Horizontal or Vertical Vent System
7.
1. With the fireplace secured in the framing, determine the vent route and identify the exterior termination location.
NOTE: This fireplace must be vented directly to the outside.
The vent system may not service multiple appliances, and must never be connected to a
flue serving a separate solid fuel burning appliance.
If you require a rear vent unit, check to see if rear venting has a vent cap and insulation in place. If so, remove cap and any insulation
in vent pipes, make sure flue is open completely to firebox inside. Once flue pipe has clear passages on inner and outer pipes, proceed
with vent connections.
Preparing 45" Fireplaces for Top Venting Configuration
If you require a top vented unit, follow the next steps to convert before use.
Step 1. Remove the 8 screws
holding top vent cover plate and
gasket. Retain screws.
Step 5. Remove and discard
the large round gasket attached
to the back of the unit. Install
the cap from the top onto the
rear pipe by bending tabs out
securing with screws to rear
outer wrapper.
Step 9. Remove the 4 screws
around the rear vent and use
to Re-install block off plate and
gasket over the rear vent flue.
20
The following sections describe vertical (roof) and horizontal (exterior wall) vent applications. Use only approved
vent components (Pages 45 and 46).
NOTE: The vent pipe is tested to be run inside an enclosed wall (such as a chase). There is no
requirement for inspection openings in the enclosing wall at any of the joints in the vent pipe.
Step 2. Remove the round flue
cover from top venting outlet
and all insulation from inside
flue inner and outer pipe.
Step 6. Reinstall screws to seal
holes in wrapper.
Step 10. Using the 2 screws
from the rear vertical baffle,
Install the top baffle (shipped in
bottom of unit) see photo.
WARNING
Step 3. Remove all insulation
from inside flue inner and outer
pipe. Retain insulation.
Step 7. Remove the rear
vertical Baffle from top, retain
screws but discard baffle.
Reinstall screws to seal holes
after vertical baffle is removed.
Discard the vertical baffle.
Step 11. Ensure flue passage
is clear to inside of firebox,
and that outer pipe is free of
insulation.
Installation
900004-00, 03/2018
Step 4. If rear vent does not
have a cap already installed,
pack inner and outer pipe with
the insulation from top.
Step 8. Remove the 2 screws
holding the block off plate and
gasket to top vent flue. Retain
screws as they will be re-used.
Unit is now ready to install
as top-venting fireplace.