Table of Contents
Advertisement
Starting a program
Start the program by closing the door
within four seconds of the last press
of a button.
The program will begin.
The Optical Interface comes on to show
that a program has been started.
If you do not close the door within
four seconds, the indicator light of
the selected program will flash and
the message
Press OK to start
pear in the display.
The program cannot be started until
you press the OK button and close
the door within four seconds.
A program should only be canceled
in the first few minutes, if at all. Oth-
erwise important program stages
could be omitted.
Time display
The estimated duration of the program
selected appears in hours and minutes
in the display before the program be-
gins. During the program, the time left
until the end of the program can only be
viewed with the door open.
Each program phase is indicated by a
symbol:
will ap-
The program duration displayed may
vary with the same program. It is influ-
enced by, among other things, the wa-
ter temperature at each intake, the re-
activation process, the softener assem-
bly, the type of detergent, the amount
of dishes, and the amount of soiling.
When a program is selected for the first
time, the display will show the average
program duration for a cold water in-
take.
The times shown in the program over-
view refer to standard test loads and
temperatures.
Each time a program is run, the elec-
tronic module calculates the program
duration required depending on the
temperature of the water taken into the
dishwasher and the amount of dishes.
Pre-wash / Soak
Wash
Interim rinse
Rinse cycle
Drying
Finish
Operation
51
Advertisement
Table of Contents
