Sony MHC-GNX60 Service Manual page 22

HCD-GNX60/GNX70/GX9900
[CD SHIP MODE (WITHOUT MEMORY CLEAR)]
• This mode moves the optical pick-up to the position durable
to vibration. Use this mode when returning the set to the
customer after repair.
Procedure:
1. Press button to turn the set ON.
?/1
2. Select CD function.
3. Press [CD] button and
?/1
will power off automatically.
4. After the "STANDBY" blinking display finish, the message
"LOCK" appears on the fluorescent indicator tube and the
CD ship mode is set.
[CD POWER MANAGE]
• This mode let you switch on or off, the power supply to the
BU during TUNER function.
• When CD POWER is set to OFF, the power supply to the BU
is cut off during TUNER function. It will increase the time
taken to access CD when function change from TUNER to
CD but it will improve tuner reception.
• When CD POWER is set to ON, the power supply to the BU
is not cut off during TUNER function. It will reduce the time
taken to access CD when function change from TUNER to
CD but it will decrease tuner reception performance.
Procedure:
1. Press button to turn the set ON.
?/1
2. Select CD function.
3. Press button to turn the set OFF.
?/1
4. Press x button and
?/1
will power on automatically.
5. The message "CD POWER ON" or "CD POWER OFF"
appears on the fluorescent indicator tube.
20
button simultaneously. The set
button simultaneously. The set
[CD TRAY LOCK MODE]
• This mode let you lock the disc trays. When this mode is
activated, the disc tray will not open when
button or [EX-CHANGE/DISC SKIP] button is pressed. The
message "LOCKED" appears on the fluorescent indicator tube.
Procedure:
1. Press button to turn the set ON.
?/1
2. Select CD function.
3. Press x button and
Z
simultaneously and hold down until "LOCKED" or
"UNLOCKED" appears on the fluorescent indicator tube
(around 5 seconds).
[VIDEO/MD SWITCHING]
• This mode let you switch from VIDEO to MD and vice-versa.
Procedure:
1. Press button to turn the set ON.
?/1
2. Select VIDEO function.
3. Press [VIDEO/MD] button and
The function will change to MD. Press the same buttons again
to change from MD to VIDEO.
[REMOTE COMMANDER DISABLE MODE]
• This mode let you disable the remote commander reception.
When this mode is activated, the set will not response if the
button on the remote commander is pressed. The message
"RemoteDisable" will be displayed on the fluorescent indicator
tube. Use this mode during aging to avoid disturbance.
• Procedure:
1. Press x button, [GROOVE] button and [DISC 2] button
simultaneously.
The message "RemoteDisable" appears on the fluorescent
indicator tube. To enable the remote commander reception,
press the same buttons again.
The message "RemoteEnable" appears on the fluorescent
indicator tube.
Z
OPEN/CLOSE
button
OPEN/CLOSE
button simultaneously.
?/1