Advertisement
RX-6000VBK/RX-6008VBK/RX-6100VBK
Removing each board in the front panel
assembly (See Fig.17 to 20)
Prior to performing the following procedure, remove
the top cover and the front panel.
1.
Pull out the volume knob on the front side of the front
panel and remove the nut attaching the volume
board.
2.
Remove the three screws N attaching the volume
board on the back of the front panel and disconnect
the harness from connector CN411 on the volume
board.
3.
Remove the ten screws O
control board and disconnect the harness from
connector CN402 on the system control board.
4.
Remove the six screws P attaching the operation
switch board. Push each tab b of the four joints
inward and detach the operation switch board to the
front.
5.
Remove the screw Q attaching the operation switch
board.
2-6
attaching the system
System control board
Front panel assembly
Volume knob
Fig.17
O
O
O
CN402
Fig.18
P
Tab b
P
Fig.19
Q
System control board
Fig.20
Nut
O
N
CN411
N
Volume board
Tab b
P
Advertisement
