Advertisement
Removing the volume control board
Prior to performing the following procedure, remove
the top cover and the rear panel.
ATTENTION:
It is not necessary to remove the
boards inserted to the back of the
volume control board.
1.
Disconnect the card wire from connector CN314 on
the volume control board.
2.
Cut off the three tie bands fixing the harness.
3.
Disconnect the harness from connector CN712 on
the preamplifier board.
4.
Disconnect the relay board from connector CN615
on the volume control board and CN851 on the main
board.
5.
Remove the five screws G
control board.
Removing the preamplifier board
Prior to performing the following procedure, remove
the top cover.
1.
Disconnect the harness from connector CN712 on
the preamplifier board and cut off the one tie band.
2.
Disconnect the preamplifier board from connector
CN711 and CN713 on the main board.
(See Fig.8)
attaching the volume
(See Fig.9)
RX-6000VBK/RX-6008VBK/RX-6100VBK
Relay board
Tie band
CN615
CN851
CN314
G
G
Volume control board
Fig.8
Preamplifier board
Main board
CN713
Fig.9
Tie bands
Preamplifier
board
CN712
CN712
Tie band
Main board
CN711
2-3
Advertisement
