Cleaning Instructions; Maintenance - Robot Coupe HI Series Instruction Manual

CARE OF YOUR MIXER
CAUTION:
ALWAYS DISCONNECT OR UNPLUG THE ELECTRICAL POWER FROM THE MIXER BEFORE
CLEANING.
The mixer is designed for simple maintenance carried out by operators. It may be necessary from time
to time to apply a little Vaseline and oil to the rods on which the bowl cradle slides. If so, use a little food
quality lubricant, ensuring that there is no excess oil that could contaminate the food mix.
Clean the mixer thoroughly after use. After isolating the machine from the electricity supply, the body
should be wiped down with a damp cloth. Do not spray the machine with or immerse it in water. Do not
forget to clean the rear of the machine and do not allow the rear vents to become blocked as this may
result in overheating.
Pay particular attention to the bowl pins and any surrounding areas of the cradle to prevent the
accumulation of mix, as this could prevent correct location of the bowl. For the same reason ensure that
the beater shaft and each of the sockets on the tools are cleaned thoroughly. The bowl and tools should be
washed in hot soapy water, rinsed and dried before being put into storage. Do not wash the agitator s in a
dishwasher, as the polished finish will be adversely affected by the dishwashing chemicals.
- It is recommended that any servicing or maintenance work must be carried out by a trained
technician or electrician.
CAUTION:
- ALWAYS DISCONNECT OR UNPLUG THE ELECTRICAL POWER FROM THE MIXER BEFORE
DOING MAINTENANCE.

MAINTENANCE

Regular maintenance is necessary on all machines if they are to remain in good working condition. It is
strongly recommended that all maintenance must be carried out by trained technicians from an appointed
distributor.
ON A REGULAR BASIS
Clean the machine thoroughly after use and lubricate the rods with Vaseline or lubrication oil which
the bowl cradle slides. After cleaning the beater shaft, please wipe and lightly lubricate the beater shaft
with Vaseline to prevent rusting. (SEE CARE ON YOUR MIXER)
ON AN ANNUAL BASIS*
Check that all bolts are tight and bowl guard secure.
※ Carry out on a more frequent basis if machine is arduously used.
※ After replacing the parts by technicians, please screw back tightly with anti-leaking coat to avoid the
gear oil leaking after replacement.
※ Do not insert any object into the air vent of motor or into the bowl.
※ Please unplug while not using the mixer.

Cleaning Instructions

Maintenance
10