Table of Contents
Advertisement
OPERATING INSTRUCTIONS
14
Dehumidification Mode
In rainy season or high humidity climate, it is
possible to operate simultaneously
dehumidifier and cooling mode to remove
humidity effectively.
1
Press
button to turn on the indoor.
c
2
Press
button to select dehumidification
mode
- Room temperature will be displayed after
desired temperature is indicated at
display section for about 5 seconds.
Power Cooling/Heating Mode
Strong cooling/heating will be conducted in
short time.
1
Press
button to turn on the indoor.
2
Press
button to operate power
cooling/heating mode.
- When power (cooling/heating) button is
pressed during cooling/dehumidification
mode, power cooling will be operated.
In power cooling mode, desired
temperature is set to 18°C and the
horizontal louver is fixed at the highest
position.
- When power (cooling/heating) button is
pressed during heating operation, power
heating will be operated.
In power heating mode, desired
temperature is set to 30°C and the
horizontal louver is fixed at the lowest
position.
Fan Mode
Heat Pump
1
Press
button to turn on the indoor unit.
4
2
Press
button on remote controller to
circulate indoor air.
- When canceling operation, press
button once more.
- During fan mode, outdoor fan and
compressor will not be operated.
- During fan mode, indoor unit turns on the
fan speed lamp and room temperature
lamp of its display panel.
Simple Reservation
Turning ON reservation mode
This function is able to turn on unit after a
setting time.
1
When the unit is turned off, adjust desired
setting time with
- Up to the maximum of 24 hours can be
selected.
Turning OFF reservation mode
This function is able to turn off unit after a
setting time.
1
When the unit is turned on, adjust desired
setting time with
- Up to the maximum of 7 hours can be
selected.
NOTE
!
After performing the setting, if corresponded
setting button is pressed once, remaining
setting time will be displayed, and if it is
pressed once again, corresponded setting
function will be cancelled. (same function as
) Remaining setting time will be displayed
with the unit of 1 hour.
4
button.
button.
Advertisement
Table of Contents
