Operating Instructions; Cooling Mode; Heating Mode; Airflow Setting - LG APNQ30GS1K1 Owner's Manual

OPERATING INSTRUCTIONS

Cooling Mode

1
Press button to turn on the indoor.
a
2
Press button to select Cooling
operation mode.
- When canceling operating, press
button once more.
3
Adjust the desired temperature by
pressing ( ) buttons.
- If desired temperature is higher than
room temperature, cooling cannot be
conducted.
- Set the temperature lower than the room
temperature
- Setting Temp Range : 18 °C~30 °C.
NOTE
!
What is 3 minutes delay function?
The reason that cold wind is not coming out
when operating the unit after turning off the
cooling is because of the function to protect
compressor. Cold wind will be coming out
when compressor is operated after 3 minutes.

Heating Mode

Heat Pump
1
Press button to turn on the indoor.
d
2
Press button to select Heating
operation mode.
- When canceling operation, press
button once more.
3
Adjust the desired temperature by
pressing ( ) buttons.
- If desired temperature is lower than room
temperature, heating cannot be
conducted.
- Set up desired temperature higher than
the room temperature
- Setting Temp Range : 16 °C~30 °C.
NOTE
!
Preheating operation
When conducting heating operation at the
condition of low outdoor temperature, the case
that wind is not coming out for several
minutes under the state of lighting of defrost
lamp may be occurred. This is the preheating
stage to supply warm wind which will be
supplied subsequently in short time.
OPERATING INSTRUCTIONS
Airflow Setting
We can simply adjust the desired airflow
direction.
Up/Down Airflow Direction Control
1
Press button to turn on the indoor.
Press I button and the louvers will swing
2
up and down.
Press I button again to set the horizontal
3
louver at the desired airflow direction.
Left/Right Airflow Direction Control
1
Press button to turn on the indoor.
Press J button and the louvers will
2
swing left and right.
Press J button again to set the vertical
3
louver at the desired airflow direction.
<Airflow Setting Table>
Symbol
I
Up·Down : Vane move from up to
down automatically and
continuously
J
Left·Right : Vane move from left to
right automatically and continuously

Fan Speed Setting

1
Press button to turn on the indoor.
4
2
Press button to select fan speed.
- You can select the fan speed in four
steps Low, Mid, High, Super High.
Each time the button is pressed, the fan
speed mode is shifted.
- Air flow rate can be selected during the
cooling, heating, dehumidification,
blowing, and auto operation mode.
13
Description