Friedrich MRM36Y3J Installation And Operation Manual page 9

Remote Control Instructions
1
START / STOP
:
Press this button to turn on the unit .Press this button again to turn off the unit.
2
Press this button to decrease set
to rapidly decrease set temperature. In AUTO mode, set temperature is not
adjustable.
3
:
Press this button to increase set temperature. Hold it down for 2 seconds
to rapidly increase set temperature. In AUTO mode, set temperature is not
adjustable.
4 FAN AUTO :
This button is used for setting Fan Speed in the sequence that goes from AUTO,
,
, to
5 MODE :
Each time you press this button, a mode is selected in a sequence that goes from AUTO,
COOL,DRY, FAN,and HEAT
AUTO
*Note: Only for models with heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
6
7
CLOCK :
Pressing CLOCK button,
present time. Holding down either button above 2 seconds increases or decreases the
time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During
blinking after setting, press CLOCK button again to confirm the setting, and then
will be constantly displayed.
Remote Controller Description
temperature. Hold it down for 2 seconds
,
then back to Auto.
Auto
Medium speed
Low speed
, as the following:
*
FAN HEAT
COOL DRY
blinks. Within 5 seconds , pressing + or - button adjusts the
High speed
*