Normal Mode Startup - Tripp Lite SmartOnline SU10KRT1X Owner's Manual

6 – Standard Operation

6-3 Normal Mode Startup

1. Confirm that the UPS system is properly grounded.
2. Make sure the utility AC supply circuit breaker and the UPS system's input breaker are switched off.
3. Wire the utility AC supply circuit and output circuit to the UPS system's terminal block and connect the external battery pack, following the
instructions in Section 5 – Wiring.
4. Switch on the utility AC supply circuit breaker and the UPS system's input breaker. The green line LED (
indicate the utility-supplied AC line voltage of the AC supply circuit is nominal.
5. If the UPS system is operating in a parallel redundancy configuration, the LCD screen will display
operating in a standalone configuration, the LCD screen will display
6. The UPS system is now in bypass mode and will automatically proceed to the UPS system self-test.
7. If there are no abnormal/fault/error messages, the pre-startup of the UPS system has been successful and the battery charger begins to
charge the external battery pack.
8. Press the ON button for approximately 3 seconds, then release it. The UPS will beep twice and the LCD screen will change from
9. The UPS system will perform another self-test, and the LCD screen will change from
4 seconds. If the self-test is successful, the LCD screen will change to
change to , then an error code will be shown. If an error code is shown, refer to Section 9 – Troubleshooting.
E2
10. If the self-test is successful, the UPS system startup is complete. Allow the batteries to charge for 12 hours in order to ensure that connected
equipment will continue to operate without interruption during a power failure. Once the UPS system is in use, it will charge the batteries
and maintain the charge level automatically.
A1
This screen indicates initial startup.
A2
This screen indicates parallel configuration.
B
This screen indicates the UPS inverter is off.
continued
A1
E1
C
This screen shows the line voltage.
D
This screen indicates that a test is underway.
E1
This screen indicates a successful self-test.
13
then
A1
then .
B
to and switch to battery mode for approximately
C D
, then . If the self-test is unsuccessful, the LCD screen will
F
E2
This screen indicates a failed self-test.
F
This screen shows the line voltage.
) illuminates continuously to
then . If the UPS system is
A2 B
to
B C
.