Graphics Software Setup; Recommended Computer Configuration - GCC Technologies X500III User Manual

Set those two IP addresses to the laser machine and the PC/Laptop which you want to
communicate with laser.
Test Ping again to see if you can get normal response from destination IP, if the
communication is normal now (can get reply from destination IP), we can be sure the IP
addresses we set originally are invalid, ask the LAN administrator to provide us a proper one.
b. Directly connect the Laser machine and PC/Laptop using the RJ45 cable without any
router/switch..etc. in between, test PING and send files, if the files can be sent and the result
of PING is normal (can get response from destination IP), the Ethernet function of GCC laser
is normal, it should be something wrong in the LAN environment , ask the administrator of the
LAN to solve the problem.

4.2 Graphics Software Setup

The LaserPro X500 SERIES is compatible with graphics software that can output HPGL commands,
such as CorelDraw, Adobe Photoshop, AutoCAD, Illustrator etc.
Supported Graphic Software

Photoshop

CorelDraw

Illustrator

AutoCAD
Other software such as EngraveLab and PhotoGrav may work with the LaserPro X500 SERIES, but
are not officially supported. Any software that can output to the LaserPro Print Driver should work.
NOTE

Support will not be offered, if you experience output problems with non-
supported graphics software.

4.2.1 Recommended Computer Configuration

The LaserPro X500 SERIES operates under Windows operating systems and is designed to work on
a computer that meets the following minimum requirements.
Computer
40 232001260G(12)