Graphics Software Setup; Recommended Computer Configuration - GCC Technologies T500 User Manual

4.3 Graphics Software Setup

The LaserPro T500 is compatible with graphics software that can output HPGL commands, such as
CorelDraw, Adobe Photoshop, AutoCAD, Illustrator etc.
Supported Graphic Software

Photoshop

CorelDraw

Illustrator

AutoCAD
Other software such as EngraveLab and PhotoGrav may work with the LaserPro T500, but these
are not supported. Any software that can output to the LaserPro Print Driver should work.
TIP
When you have the mass cutting production, we will suggest that you can select AutoCAD
to work with the LaserPro T500 to have better output performance.
NOTE

Support will not be offered, if you experience output problems with non-supported
graphics software.

4.3.1 Recommended Computer Configuration

The LaserPro T500 operates under Windows operating systems and is designed to work on a
computer that meets the following minimum requirements.
Computer

CPU

RAM

FDD

HDD

SVGA

On Board Parallel Mode (Enabled from your motherboard's BIOS):

SPP – Preferred Mode

ECP – Cable (Less than 1.8 meters)
Pentium 90 (or equivalent) or greater
32MB or higher
One 3.5" 1.44 MB Floppy Disk Drive
1.2 GB Hard Drive or greater
15" Super VGA Monitor
69 232002080G(09)