4.2 Graphics Software Setup
The LaserPro Spirit Series is compatible with graphics software that can output HPGL commands, such
as CorelDRAW, Adobe Photoshop, AutoCAD, Illustrator etc.
Supported Graphic Software
•
Photoshop
•
CorelDRAW
•
Illustrator
•
AutoCAD
Other software such as EngraveLab and PhotoGrav may work with the LaserPro Spirit Series, but
LaserPro does not guarantee 100% compatibility for those software and will not provide technical support
for them.
NOTE
Technical support will not be offered, if you experience output problems with
non-supported graphics software.
4.2.1 Recommended Computer Configuration
The LaserPro Spirit Series operates under Windows operating systems and is designed to work on
a computer that meets the following minimum requirements.
Computer Compatibility
•
CPU
–
Pentium 90 (or equivalent) or greater
•
RAM
–
32 MB or higher
•
HDD –
1.2 GB Hard Drive or greater
•
SVGA –
15" Super VGA Monitor
•
On Board Parallel Mode (Enabled from motherboard's BIOS)
•
SPP
–
Preferred Mode
•
ECP
–
Cable (Less than 1.8 meters)
Software Compatibility
•
The LaserPro Spirit Series drivers are designed for Windows Vista, 7, 8, or other operating systems
developed subsequently.
4.3 Installation of the LaserPro Print Driver
1)
Insert the LaserPro CD.
2) From the auto run menu, select Model Name, L a s e r P ro D riv e r to begin the LaserPro Print
Driver installation.
3)
When the Add Printer Wizard menu comes up, click Ne xt to continue.
4)
At the Local or Network Printer page, select < Loc a l print e r a tt a ch e d to this comput e r >, then click
Ne xt to continue.
5)
At the Select a Printer Port page, select <U s e th e following port > and select the port that the
LaserPro Spirit will be attached to, then click Ne xt to continue.
6)
The next screen will prompt you with a list to select the manufacturer and model of your printer.
From this menu, click Ha v e D isk . Another menu will now pop up for you to indicate the location
57
232001290G(13)