Wireless Remote Controller - LG APNQ100LFT0 Owner's Manual

Wireless remote controller

Heat Pump
1
2
3
7
8
11
Control
No.
panel
r
1 Remote controller operation lamp
5
Power ON/OFF button : Operation will
|
4
2 start when this button is pressed, and
stop when the button is pressed again.
6
4
Indoor fan speed button : To select the
3
desired fan speed.
9
FAN SPD
4 Temperature setting button
10
A
5 Cooling button
12
B
6 Heating button
Dehumidification button : Can effectively
D
7 remove humidity when at the time of
rainy season or high humidity.
Auto Operation button : Auto heating and
C
8 cooling Operation is conducted in accor-
dance with setting Temperature.
9 Fan mode button
Power cooling and heating mode button :
10 Powerful cooling and heating are
performed
ON/OFF timer setting button : Set the
11
time of starting or stopping
12 Timer cancel button
Handling the remote control
- Aim at the signal receptor on the floor standing type air
conditioner when operating.
- Block a strong light over the signal receptor with a curtain
or etc. so as to prevent the abnormal operation. (ex: elec-
tronic quick start, ELBA, inverter type fluorescent lamp)
- Be sure that there are no obstructions between the re-
mote control and the signal receptor.
- Do not drop or throw the remote control.
- Do not place the remote control in a location exposed to
direct sunlight, or next to a heating unit, or other heat
source.
PRODUCT INTRODUCTION
Description
11