Table of Contents
Advertisement
Condition/Problem
Resistance does not
change (machine turns on
and operates)
Console shuts off (enters
sleep mode) while in use
Unit rocks/does not sit
level
Pedals loose/unit difficult
to pedal
Clicking sound when
pedaling
Seat post movement
Things to Check
Check magnet position
(requires shroud removal)
Check Speed Sensor
(requires shroud removal)
Batteries (if equipped)
Check Console
Check data cable integrity
Check data cable
connections/orientation
Check Servo Motor
(requires shroud removal)
Check electrical (wall)
outlet
Check connection on
console
Check data cable integrity
Check data cable
connections/orientation
Reset Machine
Check magnet position
(requires shroud removal)
Check Speed Sensor
(requires shroud removal)
Check leveler adjustment
Check surface under unit
Check pedal to crank arm
connection
Check crank arm to axle
connection
Check pedal to crank arm
connection
Check locking pin
Check adjustment knob
Magnets should be in place on pulley.
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Replace batteries and check for proper operation.
Check for visual sign that Console is damaged. Replace Con-
sole if damaged.
All wires in cable should be intact. If any are visibly crimped or
cut, replace cable.
Be sure cable is connected securely and oriented properly.
Reseat all connections. Small latch on connector should line up
and snap into place.
If magnets move, adjust until they are within the proper range.
Replace Servo Motor if not functioning properly.
If the above steps do not resolve the problem, contact your lo-
cal distributor for further assistance.
Make sure unit is plugged into a functioning wall outlet.
Connection should be secure and undamaged. Replace
adapter or connection at unit if either are damaged.
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Magnets should be in place on pulley.
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Adjust levelers until bike is level.
Adjustment may not be able to compensate for extremely un-
even surfaces. Move bike to level area.
Pedal should be tightened securely to crank. Insure connection
is not cross-threaded.
Crank should be tightened securely to axle. Be sure cranks are
connected at 180 degrees from each other.
Remove pedals. Make sure there is no debris on threads, and
reinstall the pedals
Be sure adjustment pin is locked into one of the seat post
adjustment holes.
Be sure knob is securely tightened.
Solution
35
Advertisement
Table of Contents
