Table of Contents
Advertisement
7. LOG #5: Locate and install Log #5. This Log does not
have any "burn out" features painted on the log. The
"left" end of this log will rest on the base pan and con-
tact the hand bend tab indicated in Figure 9. the "right"
end will rest on the "left" end of Log #1. See Figure 9.
HAND BEND TAB
1
5
3
Figure 9. Install Log #5
8. LOG #6: Log #6 will rest on the voids of Log #1 and
Log #3 and the base pan lip as shown in Figure 8. In-
stall log by placing it on top of the log voids. The tip of
the log will contact the hand bend tab nearest the base
pan lip. See Figure 10.
1
5
3
Figure 10. Install Log #6
9. LOG #7: Log #7 will rest on the two voids of Log #2
and Log #6 as shown in Figure 10, install log by plac-
ing it on top of these voids. Place the log so that the
bark detail faces the back wall of the firebox. See
Figure 11.
1
5
3
Figure 11. Install Log #7
64
Majestic • QUARTZ32, QUARTZ36, QUARTZ42 Installation Manual • 2412-980 Rev. Q • 3/19
2
4
VOIDS FOR LOG #7
2
6
4
HAND BEND TAB
2
6
7
4
10. LOG #8: Log #8 will rest on the flat surface of Log #2
as shown in Figure 12. The right end of Log #8 will
rest on the base pan and contact the hand bend tab
indicated in Figure 12.
1
5
3
Figure 12. Install Log #8
11. This product is shipped with a bag of Lava Rock. Ap-
proximately one third of the bag will be used for initial
setup, the remainder should be placed in the manual
bag assembly and left with the homeowner. Do not
store beneath the appliance. Install Lava Rock by
placing it (by hand) in the locations denoted by arrows
in Figure 13. Care should be taken to avoid placing
lava rock on the burner.
NOTICE: DO NOT place lava rock on burner. Flame
appearance could be affected.
1
5
3
Figure 13. Lava Rock Locations
2
6
8
7
4
BASE PAN LIP
2
6
8
7
4
HAND
BEND
TAB
Advertisement
Table of Contents
