Table of Contents
Advertisement
WARNING: Do not allow non-
combustible materials to cover
any necessary openings.
WARNING: Do not fi ll the
spaces around the fi rebox with
insulation or other materials.
WARNING: Framing may be
placed or rest against fi replace
spacer, however; framing must
never be notched.
WARNING: Do not alter, cut
or modify fi replace spacers.
INSTALLING GAS LINE
NOTICE: A qualifi ed service per-
son must connect heater to gas
supply. Follow all local codes.
IMPORTANT: See Connecting to Gas Supply
in your log set owner's manual for details on
gas hookup.
You may run gas line from either side or back
of fi rebox (see Figure 9). Decide which side
you want to run gas line from.
NOTE: This is one option for installing shutoff
valve. Check local codes for equipment shut-
off valve location requirements.
Locate recessed knockout in one fi rebrick liner
(see Figures 9 and 10). Firmly tap center
of knockout with a chisel until it is released.
Carefully chisel rough edges of hole you have
made to smooth edges. This hole will line up
with hole in outer casing.
CAUTION: Do not use exces-
sive force to remove the knock-
out. Too much force may damage
the fi rebrick concrete insert.
126709-01_C
INSTALLATION
Continued
Knockout
Locations
(Knock Out
One Hole)
Figure 9 - Installing Gas Line and
Equipment Shutoff Valve (Model May
Firebrick Side Wall
Knockout
Figure 10 - Location of Knockout for
SuperiorFireplaces.us.com
Equipment
Shutoff
Valves (Install
One)
Gas Line
Hole
Vary From Illustration)
Chisel
Gas Line
Side
View
Remove
this Area
13
Advertisement
Table of Contents
