Electrical Safety - Black & Decker TPD1400EXT Manual

ENGLISH
Chargers
Your charger has been designed for a
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace
the charger unit with a regular mains
plug.
Use your Black & Decker charger only
u
to charge the battery in the appliance
with which it was supplied. Other bat-
teries could burst, causing personal
injury and damage.
Never attempt to charge nonrecharge-
u
able batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be placed
u
in a well ventilated area when charg-
ing.

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
# appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
w
corresponds to the voltage on the rating plate.
Short circuit proof safety isolating transformer. The
mains supply is electrically separated from the
transformer output.
12
(Original instructions)
x
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Removable handle
3. Handle release ring
4. Hose
5. Transparent door
6. LED charging indicator
7. Battery housing
8. Door latch
9. Bowl release button
10. Removable dust bowl
11. Accessory clip
12. 2-in-1 combi nozzle accessory
13. Crevice tool
14. Charging base
15. Accessory storage mount
16. Extension Tubes
17. Adaptor
18. Floor head
ever worn or damaged.
dealer (cat. no. VF90):
Battery
Z
If you want to dispose of the product yourself, the
battery must be removed as described below and
disposed of in accordance with local regulations.
Run the battery down completely.
u
Remove the dust bowl.
u
Remove the two screws from inside the tunnel that the
u
Detach all lead connections from the battery pack.
u
Carefully remove the cover which hold the battery pack in
u
place.
Remove battery pack and place in suitable packaging to
u
ensure that the terminals cannot be short-circuited.
Take the battery to your service agent or to a local recy-
u
cling station.
-