Electrical Safety - Black & Decker DVA315J Manual

ENGLISH
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
# appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charger is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the +
date code.
Read all of this manual carefully before
using the appliance
Only use with charger S003AQ-15
S003AQ-15
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Dust chamber release button
3. Dust chamber
4. Flip down brush
5. Wall bracket
6. Charger
7. Hanging attatchment
6
(Original instructions)
Use
Switching on and off (Fig. A)
Push the On/off power switch (1) to the forward position to
u
turn on the unit.
Returning the On/off power (1) switch will turn the unit off.
u
Flip down brush (Fig. B)
Flip the brush attachment (4) into position as shown in
u
figure B.
Using the pull out crevice tool (Fig. C)
Extend the crevice tool (8) as shown in figure C, until it
u
clicks in place.
Note: The flip down brush (4) can only be utilised when the
crevice tool is in the retracted position.
Fitting the wall bracket (Fig. D)
Fit the wall bracket (5) to a suitable wall (preferably near a
u
power outlet) using the screws provided.
The unit can then be stored, when not in use, or during the
u
charging procedure, utilising the hanging attachment (7).
Charging (Fig. E, F)
Place the charger (6) into the charging port (9) on the
u
handle of the unit as shown in figure E.
Place the charging plug into a power outlet and switch on
u
as shown in figure F. The charger LED will light.
Cleaning the filters (Fig. G, H, I, J, K)
Press the dust chamber release button (2) as shown in
u
figure G.
Seperate the dust chamber (3) from the motor unit as
u
shown in figure F.
You can use the easy empty feature as shown in figure I.
u
Lift the filter (8) out of the dust chamber (3) using the tab
u
(10) provided.
Empty the dust bowl (3) by lightly shaking over a suitable
u
container as shown in figure K.
Rinse out the dust-bowl with warm soapy water.
u
Wash the filters with warm soapy water as shown in figure
u
L.
Allow the filters to dry naturally, using heat may cause the
u
filters to distort.
Refit the filter (8) into dust chamber (3). Make sure the
u
filter tabs (11) face forward. Never place the filters into
the dust chamber backwards.
Replace the dust chamber onto the motor unit. Make sure
u
the release button (2) clicks into place.
Warning! Before performing any maintenance or cleaning on
the appliance, unplug the appliance.