Table of Contents
Advertisement
Weekly Cleaning
1.
Perform the Daily Cleaning steps 1 and 2.
2.
Remove the hair pocket from the head & cutter assembly (Diagram A).
Place the body of the shaver aside.
3.
Slide the blue cutter support frame upwards towards the direction of
the two cutters to release it from the assembly (Diagram C).
4.
Lift and remove the cutter support frame away from the cutters.
5.
Remove the cutters (Diagram D).
6.
Thoroughly rinse away any debris from inner and outer cutters with
warm water.
7.
Replace the inner cutters (Diagram E).
8.
Hold the cutter support frame with the raised centre section facing
upwards. Place it over the cutters so that the centre mouth opening is
facing the botttom cutter. Slide the cutter carrier downwards until the
locking tab locks under the centre triangle (Diagram F).
9.
Lubricate each cutter with Remington Shaver Saver (SP4).
10. Gently reattach the hair pocket to the neck assembly until it locks in
place on all three sides. The hair pocket may be reattached in any
configuration (Diagram G).
12
Advertisement
Table of Contents
