LG GR-M307QGS Owner's Manual page 16

Sxs
Table of Contents

Advertisement

Fresh Air Filter
The Fresh Air Filter helps remove odors from the refrigerator. The
Fresh Air Filter has two settings, Auto and Power(PWR). In Auto
mode, the Fresh Air Filter will cycle on and off in increments of ten
minutes on and one hundred ten minutes off. If set to the
Power(PWR) mode, the Fresh Air Filter will stay on continuously for
four hours, cycling on and off in increments of ten minutes on and five minutes off.
After four hours, the Fresh Air Filter will switch back to Auto mode.
Change Filter
- Replace Filter notification.
2
1
- After replacing the filter, press and hold the `Reset' button for approximately 3 seconds
to complete replacement of the filter.
It is recommended to change the air filter approximately every six months.
Express Frz
This function increases both ice making and freezing capabilities.
• When you touch the `ON' button, this function will automatically
shut off after 24 hours.
• You can stop this function manually by touching the `OFF' button.
Smart Saving
The Smart Saving function disables the mullion heater located on the
refrigerator door in order to conserve electricity. Touch the On or Off
button to turn the Smart Saving feature either on or off.
Lock
If you enable the Lock to prevent a mistake, you can not touch
any button except unlock button.
• Activate the Lock to disable every function on the display except for
the Lock button.
• To activate the Lock, press and hold the Lock button for approximately three seconds.
The Lock icon will display and the Lock function is now enabled.
• When the Lock function is activated, no other buttons will work. The dispenser pad is
also deactivated.
• To disable the Lock function, press and hold the Lock button for approximately three
seconds.
Power Saving
When the refrigerator is in the Power Saving Mode, the display will remain off until a
Mode
door is opened or a button is pressed. Once on, the display will remain on for 1 minute
and photo slide show. Photo slide show time can be set in Settings > Screen Saver.
16
`Replacement' is shown on the screen.
Reset Button will activate.
NOTE
Discontinue using the Eco Friendly function if excessive moisture begins to collect on
the door mullion.
Operation

Advertisement

Table of Contents
loading

Table of Contents