NETGEAR BR200 Hardware Installation Manual page 21

The four mounting holes must be in a square at precise distances of 4 inches
(100 mm) from each other. In the following figure, each green arrow represents
100 mm.
3. Drill holes into the wall for four anchors in which you will insert M4 x L25 mm screws.
The screws and anchors are in the router package.
4. Insert the anchors into the wall and tighten the screws with a No. 2 Phillips screwdriver.
Leave about ¼ inch (6 mm) of each screw protruded from the wall so that you can
insert the screws into the holes on the bottom of the router.
5. Line up the holes on the bottom panel of the router with the screws in the wall and
mount the router to the wall with the cables either at the left (see the left figure) or
right (see the right figure) of the router.
Installation
Insight Managed Business Router BR200
21 Hardware Installation Guide