Temporary Operation; Remote-A Or B Selection - Toshiba RAS-M05J2KVSG-E Service Manual

Item
6. Temporary
Pressing [RESET] button starts the temporary
operation operation of [AUTO] operation. When keeping
[RESET] button pressed for 10 seconds or more,
the temporary [COOL] operation is performed.
Press RESET button.
Did you press [RESET] button
for 3 seconds or more?
YES
Did you press [RESET] button
for 10 seconds or more?
NO
Switch to [AUTO RESTART] control.
7. Remote-A or B Setting the remote controller
selection
To separate using of remote control for each indoor
unit in case of 2 air conditioners are installed nearly.
Remote Control B Setup.
1) Press [RESET] button on the indoor unit to turn
the air conditioner ON.
2) Point the remote control at the indoor unit.
3) Push and hold [CHECK] button on the Remote
Control by the tip of the pencil. "00" will be shown
on the display (Picture
4) Press [MODE] during pushing [CHECK]."B" will
show on the display and "00" will disappear and
the air conditioner will turn OFF. The Remote
Control B is memorized (Picture
Note : 1. Repeat above step to reset Remote Control
Operation flow and applicable data, etc.
NO
Temporary [AUTO] operation
YES
Temporary [COOL] Operation
1 .
)
to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from
factory is A.
1
1) When pressing [RESET] button, the
temporary [AUTO] operation starts.
2) When keeping [RESET] button pressed
for 3 seconds or more, Pi, Pi, Pi sound is
heard and [AUTO RESTART] control is
changed.
3) When keeping [RESET] button pressed
for 10 seconds or more, "Pi" sound is
heard and the temporary [COOL]
operation starts.
4) To stop the temporary operation, press
the button again.
1. Purpose
This operation is to operate only one
indoor unit using one remote controller.
2. Description
When operating one indoor unit in a
situation where two indoor units have
been installed in the same room or
nearby rooms, this operation prevents
the remote controller signal from being
received simultaneously by both units,
thus preventing both units from
operating.
3. Operation
The indoor unit on which the remote
2 .
)
controller selection has been set to B
receives the signal of the remote
controller also set to B.
(At the factory the remote controller
selection is set to A on all the indoor
units. There is no A setting display.)
2
- 28 -
Description