Table of Contents
Advertisement
InsTallaTIon
SECTIONS
Table of Contents
step 3 – Connecting the Computers
3.1 Using USB cables, connect each computer to the USB port in
"computer interface ports" area on product.
3.2 If computer uses audio output, e.g. speakers/headphones, connect
audio cable from its audio output port to the corresponding audio
input port on product.
3.3 If the computer uses a smart card/CAC reader, connect a USB
cable between the CAC-enabled computer and the corresponding
CAC port on product.
note:
1.
If the number of product channels is larger than the number of
sources used, make sure the computers are connected in a row
starting from computer #1. For example, if there are 3 channels
used, connect computers to channels #1, #2 and then #3.
2.
The USB cable must be connected directly to a free USB port
on the computer, with no USB hubs or other devices in between.
Belkin
Secure DVI-I KVM Switch with Audio User Manual
®
1
2
3
16
4
5
step 4 – Powering up the Computers
Power up all the at tached computer s and check for display
and peripheral functionality. All computers can be powered on
simultaneously.
note: Your computers should recognize the Switch and automatically
install the HID USB driver if necessary.
When you power on your computers, the Switch emulates both a mouse
and keyboard on each port and allows your computers to boot normally.
The computer connected to port "1" will be displayed on the monitor.
Check to see that the keyboard, monitor, and mouse are working
normally. Proceed to do this with all occupied ports to verify that all
computers are connected and responding correctly. If you encounter
an error, check your cable connections for that computer and reboot.
If the problem persists, please refer to the Troubleshooting section in
this User Manual.
6
7
8
Advertisement
Table of Contents
