Is Your Pump Ready To Go; Check The General Condition Of The Pump - Honda WT40 Owner's Manual

BEFORE OPERATION

IS YOUR PUMP READY TO GO?

For your safety, and to maximize the service life of your equipment, it is very
important to take a few moments before you operate the pump to check its
condition. Be sure to take care of any problem you find, or have your servicing
dealer correct it, before you operate the pump.
To prevent a possible fire, keep the pump at least 3 feet (1 meter) away from
building walls and other equipment during operation. Do not place flammable
objects close to the engine.
Before beginning your preoperation checks, be sure the pump is on a level
surface and the ignition switch is in the OFF position.

Check the General Condition of the Pump

• Look around and underneath the pump for signs of oil or gasoline leaks.
• Remove any excessive dirt or debris, especially around the engine, muffler,
and recoil starter.
• Look for signs of damage.
• Check that all nuts, bolts, screws, hose connectors, and clamps are tightened.
12
Failure to properly maintain this pump,
or failing to correct a problem before
operation, could result in a significant
malfunction.
Some malfunctions can cause serious
injuries or death.
Always perform a pre-operation
inspection before each operation and
correct any problems.