Lubrication; Nylon Line Head Disassembly Instructions - Echo SRM-2620T Operator's Manual

SRM-2620T
Note: Every unit is run at the factory and the carburetor is set in
compliance with emission regulations. Carburetor adjustments,
other than idle speed, must be performed by an authorized
ECHO dealer.
1. Check idle speed and reset if
necessary. If a tachometer is
available, idle speed screw (A)
should be set to the
specifications found on
"Specifications" page of this
manual. Turn idle screw (A)
clockwise to increase idle
speed; counterclockwise to
decrease idle speed.
When carburetor adjustment is completed, the cutting attachment
should not move at idle, otherwise serious personal injury may
result.

Lubrication

Level 1.
Parts Required:
Gear Housing
1. Clean all loose debris from
gear case.
2. Remove plug (A) and check
level of grease.
3. Add grease if necessary. DO
NOT over-fill.
Nylon Line Head
Disassembly
Instructions
Note: For normal use, Speed Feed® head disassembly is not
necessary. However, if circumstances require disassembly,
follow these instructions.
X7502341000
© 1/2016 ECHO Inc.
Lithium Based Grease.
MAINTENANCE
A
A
35