Remove Nylon Line Head; Support Handle Installation; Operation - Echo SRM-2620T Operator's Manual

OPERATION

Remove Nylon Line Head

Note: Do not disassemble nylon
line head.
1. Align locking hole in upper plate
with notch in edge of gear
housing and insert head locking
tool (D).
2. Remove line head (E) by turning
it clockwise until head is
completely off of shaft.
3. Remove locking tool (D).
Support Handle
Installation
Note: Label shows
minimum spacing
for support handle
location.
1. If necessary, position
support handle for
comfortable operation
and securely tighten
screws.
OPERATION
Moving parts can amputate fingers or cause severe injuries. Keep
hands, clothing and loose objects away from all openings. Always
stop engine, disconnect spark plug, and make sure all moving
parts have come to a complete stop before removing obstructions,
clearing debris, or servicing unit.
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a
poison gas. Breathing CO can cause unconsciousness, serious
injury, or death. Exhaust can cause serious burns. ALWAYS
position unit so that exhaust is directed away from your face and
body.
20
SRM-2620T
D
MIN
SPACING
© 1/2016 ECHO Inc.
E
X7502341000