Harbor Freight Tools 99780 Set Up And Operating Instructions Manual page 7

note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
1. Connect the Front Handle (25) to
the top of the Compressor with two
Knobs on each side. See Figure 1.
2. Connect the Rear Handle (18) to
the top of the Compressor with two
Knobs (29) on each side. See Fig-
ure1.
3. Connect the Front Brace (31) to the
bottom of the Air Tank (30). Secure
using four Knobs (29). See Figure 1.
4. To connect the Wheels (38), first put
a washer (35) at the end of each Axle
(34). See Figure 2.
5. Put the Axles (34) in the wheel brack-
ets and secure them using Nut (34).
See Figure 3 below.
Figure 2
Figure 4
SKU 99780-81 For technical questions, please call 1-800-444-3353.
Front
handle (25)
Knobs (29)
Front
Brace
(31)
6. Put each Wheel (38) through the Axle
(34) on each side of the compressor.
See Figure 4.
7. Put a Cotter Pin (36) through the
ends of each Axle (34) to secure the
Wheels (38). See Figure 5.
8. Firmly press the Wheel Covers (37)
on each Wheel (38) until they snap
into place. See Figure 6.
Figure 3
Figure 5
Figure 1
rear handle (18)
Wheel (38)
Knobs (29)
Figure 6
REV 08g; 10a
Page 7