Table of Contents
Advertisement
7. Insert the new thermal sensor cable into the hole
thermal-sensor plastic holder with the two holes
until it snaps into position.
Figure 21. Installing the thermal sensor
8. Connect the new thermal sensor cable to the thermal sensor connector on the system board. See
"Parts on the system board" on page 34.
9. Reinstall the front bezel. See "Replacing the front bezel" on page 90.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 126.
Replacing the power supply assembly
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
98
ThinkCentre M73p Hardware Maintenance Manual
1
in the chassis. Then align the two tabs on the
1
and
2
in the chassis, and push the plastic holder
Advertisement
Table of Contents
