How To Use Edc (Engine Diagnostic Control) Mode - Samsung CLP-325 Series Service Manual

4.1.6 How to use EDC (Engine Diagnostic Control) Mode

EDC Mode is feature that allows the engineer to check the condition of the print engine. It can check the
operating condition of the motors, sensors, solenoids and clutches, measure the High Voltage from the HVPS
and check the operation of the fuser and LSU.
4.1.6.1 Enterence
When trying to check the CLP-320N EDC Mode, additional EDC execution program needed.
[ Procedure of EDC Mode operation ]
a) First, turn on the Power of Printer, wait until Ready state
b) In this state, Run the EDC program on the computer
c) After that, click the menu of screen
d) Then <Motor Test> appears on the initial screen
e) Should you get out of this program, press Exit of screen
4.1.6.2 Keys
Key
Exit
Update LCD
Menu
Left/Right arrow
Enter
Upper level
4.1.6.3 EDC Map
Service Manual
Alignment & Troubleshooting
Discription
Close program
Update value (ex : sensor value)
Move to the top menu
Move test item
Start testing or select Sub-item
Stop testing or the upper menu
4-17
Samsung Electronics