Furuno FAR-2228 Installation Manual page 104

2. WIRING
3. Connect each line of the cable to the appropriate connectors on 03P9668 board.
• Serial lines: TB701, TB702 and TB703, through the wiring clamp (A)
• Shield line: Screw (C)
• Coaxial cable: J716 through the wiring clamp (D). Then clamp the shield part of
the coaxial cable with the cable clamp (E).
Connection of Motor power cable (From Antenna Unit)
1. Connect the lines of the cable to the appropriate WAGO connectors (TB713), re-
ferring to the interconnection diagram at the back of this manual.
2. Set the motor power cable on the upper
cable entrance, and fasten the armor
part of the antenna cable with the cable
clamp. For the clamp position, see
"TPYCY-2.5 (for Motor power
cable)" on page 2-48.
3. Connect the lines of the Motor power
cable as follows:
• Serial lines: TB713. Clamp the armor part of the cable with the cable clamp.
Note: Twist the motor power cable once to handle extra length.
2-50
(A) (A)
(B) (B)
(C) (C)
Antenna cable
TB713 TB713
TB701 TB701
TB702 TB702
TB703 TB703
J716 J716
(E) (E)
(D) (D)
Coaxial cable Coaxial cable
Motor power cable
Upper cable entrance Upper cable entrance
Twist the cable.
Motor power cable