Carbon Monoxide Detectors - DSC Neo Power HS2016 User Manual

Alarm panel
Hide thumbs Also See for Neo Power HS2016:
Table of Contents

Advertisement

Chapter 15
Consider the following when making your escape plans:
Make sure that all border doors and windows are easily opened. Ensure that they are not painted shut, and that their lock-
l
ing mechanisms operate smoothly.
If opening or using the exit is too difficult for children, the elderly or handicapped, plans for rescue should be developed.
l
This includes making sure that those who are to perform the rescue can promptly hear the fire warning signal.
If the exit is above the ground level, an approved fire ladder or rope should be provided as well as training in its use.
l
Exits on the ground level should be kept clear. Be sure to remove snow from exterior patio doors in winter; outdoor fur-
l
niture or equipment should not block exits.
Each person should know the predetermined assembly point where everyone can be accounted for (e.g., across the street
l
or at a neighbor's house). Once everyone is out of the building, call the fire department.
A good plan emphasizes quick escape. Do not investigate or attempt to fight the fire, and do not gather belongings as this
l
can waste valuable time. Once outside, do not re-enter the house. Wait for the fire department.
Write the fire escape plan down and rehearse it frequently so that should an emergency arise, everyone will know what to
l
do. Revise the plan as conditions change, such as the number of people in the home, or if there are changes to the build-
ing's construction.
Make sure your fire warning system is operational by conducting weekly tests. If you are unsure about system operation,
l
contact your installer.
We recommend that you contact your local fire department and request further information on fire safety and escape planning. If
available, have your local fire prevention officer conduct an in-house fire safety inspection.
Figure 5

15.3 Carbon Monoxide Detectors

Carbon monoxide is colorless, odorless, tasteless, and very toxic, it also moves freely in the air. CO detectors can measure the con-
centration and sound a loud alarm before a potentially harmful level is reached. The human body is most vulnerable to the effects
of CO gas during sleeping hours; therefore, CO detectors should be located in or as near as possible to sleeping areas of the home.
For maximum protection, a CO alarm should be located outside primary sleeping areas or on each level of your home. Figure 5
indicates the suggested locations in the home.
Do NOT place the CO alarm in the following areas:
Where the temperature may drop below -10ºC or exceed 40ºC
l
Near paint thinner fumes
l
Within 5 feet (1.5m) of open flame appliances such as furnaces, stoves and fireplaces
l
In exhaust streams from gas engines, vents, flues or chimneys
l
Do not place in close proximity to an automobile exhaust pipe; this will damage the detector
l
PLEASE REFER TO THE CO DETECTOR INSTALLATION AND OPERATING INSTRUCTION SHEET FOR SAFETY
INSTRUCTIONS AND EMERGENCY INFORMATION.
- 42 -

Advertisement

Table of Contents
loading

Table of Contents