Table of Contents
Advertisement
OPERATION
To avoid engine damage due to over-revving, do not block blower
pipe.
1.
Use only during appropriate hours. Contact your local government for
the ordinances affecting your area.
2.
To reduce sound levels, limit the number of pieces of equipment used at
any one time.
3.
Allow the engine to warm up at a fast idle for a few minutes.
4.
PB-580 H
Set engine speed with throttle
lever (A).
PB-580 T
Control engine speed with
throttle trigger (B), or for
continuous use, set engine
speed with throttle lever (A).
5.
Use lower speed to blow dry
leaves from walks, patios and
drives. Use rakes and brooms
to loosen debris before blowing.
6.
Additional speed may be
necessary to clean grass and leaves from a lawn or flower bed.
7.
Higher speed may be necessary to move gravel, dirt, snow, bottles or
cans from a driveway, street, parking lot or stadium.
8.
Always stop unit using stop engine procedure.
Note: Never use a higher speed setting than necessary to perform a
task. Remember, the higher the engine speed, the louder the
blower noise.
9.
Minimize dust by using blower at lower speeds or dampen surface with
water. Blower can be used to clean most surfaces when water
conservation is desired.
10. Use the full blower pipe configuration when blowing.
11. After using blowers and other equipment, CLEAN UP! Dispose of
debris in trash receptacles.
30
PB-580 H
PB-580 T
A
© 1/20 ECHO Incorporated
PB-580H/T
A
B
X7505200609
Advertisement
Table of Contents
