Amana ACR2303MFW Owner's Manual page 12

� Tighten strain relief screw against the power supply cord.
Style 2: Direct wire strain relief
� Remove the knockout as needed for the flexible conduit
connection.
� Assemble a UL listed conduit connector in the opening.
A. Removable retaining nut
B. Conduit
� Tighten strain relief screw against the flexible conduit.
5. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
And you will be
If your home has:
connecting to:
4-wire receptacle A UL Listed, 250 V
(NEMA type 14-50R) minimum, 40 A,
range power
supply cord
4-wire direct A circuit breaker
box or fused
disconnect
12
If your home has:
3-wire receptacle
(NEMA type 10-50R
3-wire direct
4-Wire Connection: Power Supply Cord
Use this method for:
� New branch-circuit installations (1996 NEC)
� Mobile homes
� Recreational vehicles
� In an area where local codes prohibit grounding through the
1. Part of metal ground strap must be cut out and removed.
2. Use a Phillips screwdriver to remove the ground-link screw
3. Feed the power supply cord through the strain relief on the
Go to Section:
4-wire connection:
Power supply cord
4-wire connection:
Direct wire
4. Use Phillips screwdriver to connect the green ground wire
And you will be
connecting to:
A UL Listed, 250 V
minimum, 40 A,
range power
supply cord
A circuit breaker
box or fused
disconnect
neutral
A. Metal ground strap
B. Discard
C. Ground-link screw
from the back of the range. Save the ground-link screw and
the end of the ground link under the screw.
cord/conduit plate on bottom of range. Allow enough slack to
easily attach the wiring to the terminal block.
A. Terminal block
B. Ground-link screw
from the power supply cord to the range with the ground-link
screw. The ground wire must be attached first.
Go to Section:
3-wire connection:
Power supply cord
3-wire connection:
Direct wire
C. UL listed strain relief
D. Power supply cord wires