Amana ACR2303MFW Owner's Manual page 10

3. Determine and mark centerline of the cutout space. The
mounting can be installed on either the left-side or right-side of
the cutout. Position mounting bracket against the wall in the
cutout so that the V-notch of the bracket is 12
from centerline as shown.
A. 12 9 / " (31.9 cm)
16
B. Bracket V-notch
4. Drill two 1/8" (3 mm) holes that correspond to the bracket
holes of the determined mounting method. See the following
illustrations.
Floor Mounting
Rear Position
Wall Mounting
10
9 / " (31.9 cm)
16
Front Position Diagonal (2 options)
5. Using the Phillips screwdriver, mount anti-tip bracket to the
wall or floor with the two #12 x 1
provided.
6. Move range close enough to opening to allow for final
electrical connections. Remove shipping base, cardboard or
hardboard from under range.
7. Move range into its final location, making sure rear leveling leg
slides into anti-tip bracket.
8. Move range forward onto shipping base, cardboard or
hardboard to continue installing the range using the following
installation instructions.
5 / " (41.3 mm) screws
8