Panasonic Lumix DMC-FZ60 Operating Instructions For Advanced Features page 212

Hide thumbs Also See for Lumix DMC-FZ60:
Table of Contents

Advertisement

The brightness or the hue of the recorded picture is different from the actual scene.
When recording under fluorescent or LED lighting fixture etc., increasing the shutter speed may
introduce slight changes to brightness and colour. These are a result of the characteristics of the
light source and do not indicate a malfunction.
When recording subjects in extremely bright locations or recording under fluorescent lighting, LED
lighting fixture, mercury lamp, sodium lighting etc., the colours and screen brightness may change or
horizontal striping may appear on the screen.
Reddish horizontal streaks appear on the LCD monitor during recording.
This is characteristic of MOS sensors which serve as the camera's pickup
sensors. It appears when the subject has a bright part. Some unevenness
may occur in the surrounding areas, but this is not a malfunction.
It is recorded in pictures or motion pictures.
It is recommended that you take pictures while taking care not to expose
the screen to sunlight or any other source of strong light.
Motion picture recording stops in the middle.
Use a card with SD Speed Class with "Class 4" or higher when recording motion pictures.
Depending on the type of the card, recording may stop in the middle.
> If motion picture recording stops during use of a card of at least "Class 4" or if you use a card
that has been formatted on a PC or other equipment, the data-writing speed is lower. In such
cases, we recommend that you make a backup of the data and then format
unit.
Object seems to be warped.
Object seems to be warped slightly when the object moves across the image very fast, but this is
because the unit is using MOS for the image sensor. This is not a malfunction.
Zoom does not operate properly.
Is the [Conversion]
(DMC-FZ200)
The zoom cannot be controlled with the side lever.
Has [Side Lever]
(P57)
> Set [Side Lever] to [ZOOM].
Subject cannot be locked.
(AF tracking not possible)
Set the AF area to the distinctive colour of the subject if there is a part that is different from the
surrounding colour.
(P145)
set to [
] or [
been set to [FOCUS]?
(P95)
Others
]?
C
- 212 -
(P68)
the card in this

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lumix dmc-fz200Lumix dmc-fz200gnk

Table of Contents