Enable Dynamic Routing On Your Router - TRENDnet TEW711BRV2 User Manual

TRENDnet User's Guide

Enable dynamic routing on your router

Routing > Dynamic
You may want to setup your router to route computers or devices on your network to
other local networks through other routers. If other routers support dynamic routing
such as RIP (Routing Information Protocol), you can enable this feature on your router
to automatically learn the required routes to reach those networks. It is required that
the same dynamic routing protocol and version is also enabled on the other routers in
order your router and the other routers to exchange information about the network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see "Access your router management page"
on page 27).
2. Click on Routing, and click on Dynamic.
3. Select the appropriate dynamic routing protocol and version communicate with other
routers.
• Transmit – Allows your router to send out network information to other
routers so other routers can dynamically build routes to your network.
Disabled – Disable sending routing information from your router to
o
other routers.
RIP 1 - Sends out routing information to other routers using the RIP
o
version 1 protocol.
RIP 2 – Sends out routing information to other routers using the RIP
o
version 2 protocol (recommended if supported by both devices).
•
Receive - Allows your router to receive network information from other router
so your router can build routes to other networks.
Disabled – Disable receiving routing information from other routers to
o
your router.
© Copyright 2013 TRENDnet. All Rights Reserved.
RIP 1 - Receive routing information from other routers using the RIP
o
version 1 protocol.
RIP 2 – Receive routing information from other routers using the RIP
o
version 2 protocol.
4. Click Apply to save the changes or click Cancel to discard the changes.
TEW-711BR
41