Table of Contents
Advertisement
RUGGEDCOM RS920W
Installation Guide
Figure 1: RUGGEDCOM RS920W
1. POWER LED 2. ALARM LED 3. EoVDSL Port 4. Wireless Ethernet Ports 5. Serial Ports 6. RS232 Console Port (Serial) 7. Failsafe
Alarm Relay 8. Chassis Ground Connection 9. Power Supply Terminal Block
POWER LED
ALARM LED
Console Port
Communication Ports
Failsafe Alarm Relay
Power Supply Terminal Blocks
Section 1.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM RS920W:
AC power cord (16 AWG)
Required Tools and Materials
3
1
2
Illuminates green when power is supplied to the device.
Illuminates red when an alarm condition exists.
The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial
console port, refer to
Communication ports in general receive and transmit data, as well as provide access to the
RUGGEDCOM ROS Web interface. For more information about the various ports available,
refer to
Chapter 4, Communication
Latches to default state when a power disruption or other alarm condition occurs. For more
information, refer to:
•
Section 2.5, "Connecting the Failsafe Alarm Relay"
•
Section 5.2, "Failsafe Alarm Relay Specifications"
Pluggable terminal blocks for connecting one or more power sources. For more information,
refer to
Section 2.6, "Connecting Power"
Tools/Materials
4
6
7
5
4
Section 3.1, "Connecting to the
Ports.
and
Section 5.1, "Power Supply
For connecting power to the device.
Introduction
8
9
Device".
Specifications".
Purpose
Chapter 1
3
Advertisement
Table of Contents
